Introduction
60
SmartNode 5550 & 4150 Series User Manual
C
• Cabling
Introduction
This section provides information on the cables used to connect the SmartNode device to the existing network
infrastructure and to third party products.
Ethernet
Ethernet devices (10/100/1000 Base-T) are connected to the SmartNode over a cable with RJ-45 plugs. All
Ethernet ports on the SmartNode device are Auto-MDX. Use any straight or crossover cable to a host, hubs,
switches, PCs or other devices.
Note
Connecting both Ethernet ports to the same switch will only work if the
switch has a separate ARP table for each connection.
Figure 15. Typical Ethernet straight-through cable diagram for 10/100Base-T
Figure 16. Typical Ethernet straight-through cable diagram for 1000Base-T
The interconnecting cables shall be acceptable for external use
an shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
CAUTION
RJ-45, male
1
2
3
4
RJ-45, male
1
2
3
4
5
6
7
8
5
6
7
8
Содержание SmartNode SN5550
Страница 58: ...59 Appendix C Cabling Chapter contents Introduction 60 Ethernet 60 Analog FXS 61 Analog FXO 63 ISDN BRI 64...
Страница 69: ...70 Appendix E SmartNode Device Factory Configuration Chapter contents Introduction 71...
Страница 73: ...Introduction 74 SmartNode 5550 4150 Series User Manual F Reset Button Functions Figure 23 SN4150 Reset button...
Страница 74: ...Introduction 75 SmartNode 5550 4150 Series User Manual F Reset Button Functions Figure 24 SN5551 Reset button...
