Patton SmartNode 4830 DSL Series, Руководство пользователя

Страница: 31 / 70

Installing the VoIP IAD 31
SmartNode 4830 DSL Series User Manual 2 • Hardware installation
Connecting to external power source
The VoIP IAD comes with an internal or external power supply. This section describes installing the power
cord into the VoIP IAD. Do the following:
Note
Do not connect the power cord to the power outlet at this time.
1. Insert the barrel type connector end of the AC power cord into the external power supply connector
(see
figure 9 ).
2.
Insert the female end of the power cord into the internal power supply connector (see figure 9 ).
Figure 9. Power connector location on rear panel
3. Verify that the AC power cord included with your VoIP IAD is compatible with local standards. If it is not,
refer to chapter 5,
“Contacting Patton for assistance” on page 46 to find out how to replace it with a com-
patible power cord.
4.
Connect the male end of the power cord to an appropriate power outlet.
5. Verify that the green Power LED is lit (see Figure 3 on page 20).
Congratulations, you have finished installing the SmartNode VoIP IAD! Now go to chapter 3, “Getting started
with the SmartNode” on page 32.
The VoIP IAD power supply automatically adjusts to accept an input
voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the power
cord into the receptacle. Failure to do so could result in equipment
damage.
Power
connector
CAUTION