Connecting Power
23
SmartNode 10100 Series User Manual
2 • Hardware Installation
Figure 6. Port Interface to the PSTN
Connecting Power
The SN10100 is furnished with two AC or DC power connections. Only once all other equipment installation
work has been completed should the SN10100 be powered up.
To power the SN10100, you will need:
•
A power source
•
Two power cables for the SN10100
Refer to the following sections for information about power:
•
•
•
Connecting to AC Power
The SN10100 AC model is furnished with two AC power connectors.
To connect the SN10100 to AC Power perform the following:
1.
Connect an AC power cable between the AC connector of the SN10100 and an AC supply (
).
Note
If the SN10100 features a second power supply and it is not connected to an
AC power source, press the green button located at the rear of the unit to dis-
able the audible alarm.
2.
Power up the SN10100 by turning on its power switch(es).
