10
SmartNode 5300 Quick Start Guide
NOTES
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
____________________________________________________________________
SmartNode 5300 Quick Start Guide
3
1.1 Models with external AC adaptor
1.
Connect female plug of the AC power cord to the AC adaptor provided.
2.
Connect the barrel-type connector of the AC adaptor to the barrel-type
Power
jack on the OnSite router.
3.
Insert the male plug of the AC power cord into an AC power outlet (100–240 VAC).
1.2 Models with internal AC power supply
1.
Insert the female end of the AC power cord into the internal power supply connector.
2.
Connect the male end of the power cord into an AC power outlet (100–240 VAC).
1.3 Models with internal DC power supply
1.
Strip insulation 1/4-inch from the electrical wires that will connect the DC power source to the OnSite.
2.
Connect the positive (+) terminal from the power source to the positive (+) terminal on the OnSite.
3.
Connect the ground terminal from the power source to the ground terminal (E) on the OnSite.
4.
Connect the negative (-) terminal from the power source with to the negative (-) terminal on the OnSite.
Figure 1.
Connecting the DC power supply
Note
“+”, “E”, and “-” may be unlabeled.
1.4 Power-up indication
The
Power
LED blinks as the OnSite is powering up. When the
Power
LED stops blinking and remains lit, the
OnSite is ready for you to configure.
2.0 Configure the IP address
The OnSite is shipped with a factory-configured IP address assigned to the
Ethernet
LAN port (green outline).
The address is
192.168.200.10/24
. In most cases, you must change the address to be on the same sub-
net as your PC, as described in the procedures below. If you are not sure which IP address to use for your instal-
lation, contact your network administrator.
2.1 Connecting a PC and logging in
1.
Using the included combination RS232/Ethernet cable and DB9-RJ45 adapter, connect a PC’s serial port
to the OnSite’s
Console
port (see
figure 2
).
+
E
-
