Inserting and Removing SFP Modules
25
FiberPlex FP1004E User Manual
2
• Installation
Identifying the Latch Type of the SFP Module
SFP module have various latching mechanisms to secure them into the SFP Cage of a device. FiberPlex Mod-
ules can support a host of manufacturers and brands of SFP Modules so the user may encounter any number of
different latches. Some of these are described below:
Inserting a Module
1.
Attach an anti-static wrist or ankle strap, following its instructions for use.
2.
Disconnect and remove all interface cables from SFP module.
3.
If the SFP module has a Bail Clasp, close the Bail Clasp before inserting the SFP module.
4.
With the gold finger connector on the bottom and the label on the top, line up the SFP module with the
empty cage and slide it in making sure that it is completely inserted and seated in the cage (see
).
Figure 13. Inserting a Module
Bail Clasp
The bail clasp SFP module has
a clasp that you use to remove
or install the SFP module.
Actuator Button
The actuator button SFP module includes a button that you push in order
to remove the SFP module from a port. This button can either lift 'Up' or
press 'In' to release the SFP module depending on the manufacturer.
Mylar Tab
The Mylar tab SFP module has
a tab that you pull to remove
the module from a port.
Slide Tab
The slide tab SFP module has a tab underneath the front of the SFP mod-
ule that you use to disengage the module from a port.
