Model 6081RC blades installation
24
Model 6081RC Network Access Server User Manual
2 • Hardware installation
•
The building ground rod (generally located at the site’s main ser-
vice entrance)
•
A sprinkler system pipe
•
A cold-water pipe
•
Building structural steel
1.
If you have not done so already, remove the Model 6081RC from its shipping container.
Note
Be sure to wear the anti-static strap to prevent electrostatic damage to
the blade.
Note
The location should be well ventilated. Do not block the rack chassis’
cooling vents.
2.
Insert the rear blade into the desired slot in the rack chassis. Make sure the blade is seated properly in the
slot guides.
Figure 6. Alignment/ESD pin and card handle
3.
Gently press the blade into the chassis until the alignment/ESD pin (see
) engages the chassis.
When the blade is fully seated, the red buttons in the handles click up automatically, thus locking the han-
dle and activating the switch (closed position). The click of the button gives a visual and audible confirma-
tion that the board is fully seated.
Card handle
Alignment/ESD pin
