BODi rS BD004 Quick Start Guide
9
5.0 Connecting the Power Supply
BODi rS comes with a terminal block for connecting to a power source. Strip the individual wires and insert into
the slots of the power connection block on the rear panel of BODi rS. Be sure to leave a little slack on the wires
so that they are not stressed or pulled too tightly. Also, make sure that the power cable wires are secured tightly
in the terminal block. Verify the connection by checking that the Power LED is lit on the front panel.
Figure 7.
Connecting BODi rS terminal block power supply
6.0 Connecting to the Web Admin Interface
After physically connecting the LAN, you may use the Web Admin interface to configure the BODi rS interfaces.
To login to the Web Admin Interface:
1.
Start a web browser on a computer that is connected to the BODi rS through the LAN port.
2.
Enter the following default LAN IP address in the address field of the web browser: http://192.168.50.1
3.
Enter the username
admin
and password
admin
to login to the Web Admin Interface. This is the default
Username and Password of the BODi rS. (You may change the Admin and Read-only User Password by
clicking on System > Admin Security
in the Web Admin Interface). After successfully logging in, the Dash-
board of the Web Admin Interface displays:
Figure 8.
Web Admin Interface home page
The Web Admin Interface Dashboard shows the current WAN, LAN, Wi-Fi AP settings and statuses. The Dashboard
enables you to change the priority of the WAN connections and switch theWi-Fi AP connections off or on. For
more information about configuring these connections, refer to Chapter 3 in the
BODi rS 007 and BD004 User
Manual:
(
www.patton.com/manuals/BD007_BD004.pdf).
4
BODi rS BD004 Quick Start Guide
1.0 Before you Begin
1.1 Gathering Network Information
Before installing the BODi rS, gather the following information about your network::
•
At least one Internet/WAN access account and/or Wi-Fi access information
•
Network connections:
–
Ethernet WAN: A 10/100BaseT UTP cable with RJ45 connector
–
USB: A 2G/3G/4G LTE USB modem
–
Wi-Fi WAN: A Wi-Fi antenna
•
A computer with TCP/IP network protocol and a web browser installed. Supported browsers include Microsoft
Internet Explorer 7.0 or above, Mozilla Firefox 3.0 or above, Apple Safari 3.1.1 or above, and Google
Chrome 2.0 or above.
1.2 Preparing to Install BODi rS
Installing BODi rS involves the following steps:
1.
Placing or mounting the BD004.
2.
Connecting a computer to the LAN port on the BD004.
3.
Connecting devices to the WAN ports on the BD004.
4.
Connecting the power connector on the BD004 to a power source.
www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299
