Patton electronics SmartNode 5531, Руководство пользователя

Страница: 26 / 58

Installing the Patton SmartNode eSBC/IAD 26
SmartNode 5531 User Manual 3 • SmartNode Installation
Connect the cables in the following order:
1. Connect the ISDN terminals and NT to the BRI ports (see section “Connecting ISDN terminals and NT
to the SmartNode’s ISDN BRI ports” )
2. Connect the 10/100/1000Base-T Ethernet LAN and WAN (see section “Connecting the 10/100/
1000Base-T Ethernet LAN and WAN cables” )
3. Connect the power mains cable (see section “Connecting the Power Supply” on page 27)
Connecting ISDN terminals and NT to the SmartNode’s ISDN BRI ports
The SmartNode comes with four ISDN BRI ports located on the rear panel (see figure 2 on page 16). All ports
can be connected to the PSTN (ISDN NT) or terminals.
Note
On Lifeline Relay models (/R option) the PSTN line should be connected to
BRI 0/0 and a terminal to BRI 0/1 to benefit from the lifeline function. (See
the full list of models on www.patton.com).
For details on the BRI port pinout and ISDN cables, refer to Appendix C, “Cabling” on page 46 and Appendix
D, “Port pin-outs” on page 50 .
Connecting the 10/100/1000Base-T Ethernet LAN and WAN cables
The SmartNode 5531 has automatic MDX (auto-cross-over) detection and configuration on the Ethernet
ports. Any of the two ports can be connected to a host or hub/switch with a straight-through wired cable.
1.
Connect to the subscriber port of the broadband access modem (DSL, cable, WLL) to ETH 0/0.
2. Connect port ETH 0/1 to your LAN.
For details on the Ethernet port pinout and cables, refer to Appendix C, “Cabling” on page 46 and Appendix
D, “Port pin-outs” on page 50.
Installation cable requirements for the DSL WAN cable (SN5531/2G, /4G, /AVA, /AVB Models)
The SmartNode Model 5531 comes with an optional G.SHDSL(EFM-ATM) or VDSL-ADSL WAN inter-
face. Use a straight-through RJ-45 cable to connect the DSL port.
For details on the G.SHDSL port pinout, refer to section “G.SHDSL EFM & ATM port (/2G and /4G mod-
els) ” on page 52.
For details on the VDSL and ADSL port pinout, refer to section “VDSL-ADSL Port (/A and /AVA & /AVB
models only) ” on page 52.
The Interconnecting cables shall be acceptable for external
use and shall be rated for the proper application with
respect to voltage, current, anticipated temperature, flam-
mability, and mechanical serviceability.
For the ISDN connection to a carrier Network, it shall be con-
nected to a Network Termination Device and not connected
directly to an outside POTS line.
WARNING
CAUTION