![background image](http://html1.mh-extra.com/html/patton-electronics/smartnode-4170/smartnode-4170_user-manual_4046113027.webp)
Introduction
27
SmartNode 4170 User Manual
4
• Initial Configuration
Introduction
This chapter leads you through the basic steps to set up a new SmartNode and to download a configuration.
Setting up a new SmartNode consists of the following main steps:
Note
If you haven’t already installed the SmartNode, refer to Chapter 3,
•
Connecting the SmartNode to your laptop PC
•
Configuring the desired IP address
•
Connecting the SmartNode to the network
•
Loading the configuration (optional)
Connecting the SmartNode to Your Laptop PC
First, the SmartNode must be connected to the main power supply with the power cable. Wait until the Power
LED stops blinking and stays lit constantly. Now the SmartNode is ready.
CAUTION
The interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
CAUTION
For the ISDN connection to a carrier network, it shall be con-
nected to a network termination device and not connected
directly to an outside POTS line.
The SmartNode 4170 Series is equipped with an Auto-MDX Ethernet port, so you can use straight-through
cables for host or hub/switch connections (see figure 6).
Figure 6. Connecting the SmartNode to your Laptop PC