Patton electronics SmartNode 07MSN4400-QS, Быстрый старт

Страница: 6 / 12

Connecting a PC, logging in, and configuring the LAN IP address 6
SmartNode 4400 Quick Start Guide
3. Type administrator as the login prompt and press the Enter key after the password prompt (do not type
anything for the password). A prompt will appear consisting of the IP address and > character.
login: administrator
password:
172.16.40.1>
4. Following log in, the SmartNode is in operator execution mode (indicated by > character in the command
line prompt). With the commands enable and configure , you enter the configuration mode.
172.16.40.1> enable
172.16.40.1# configure
172.16.40.1(cfg)#
Changing the IP address
1. Select the context IP mode to configure an IP interface.
172.16.40.1(cfg)# context ip router
172.16.40.1(ctx-ip)[router]#
2. Set the IP address and network mask for the each IP interface ( eth0 , for example).
Note For the examples in this guide, a private network ( 172.16.1 ) IP
address is used.
172.16.40.1(ctx-ip)[router]# interface eth0
172.16.40.1(if-ip)[eth0]# ipaddress 172.16.1.10 255.255.255.0
2002-10-29T00:09:40 : LOGINFO : Link down on interface eth0.
2002-10-29T00:09:40 : LOGINFO : Link up on interface eth0.
172.16.1.10(if-ip)[eth0]#
3. Make this modified configuration your new start-up configuration. On the next start-up the system will
initialize itself using the modified configuration.
172.16.1.10 (if-ip)[eth0]# copy running-config startup-config
172.16.1.10 (if-ip)[eth0]#
Go to section “Connecting the SmartNode to the LAN” on page 7 to connect the SmartNode to
your network.