4
SmartLink M-ATA Quick Start Guide
B.0 Voice prompt configuration
The M-ATA provides the ability to review and set the network configuration parameters using the handset of an
attached analog telephone handset.
By default from the factory, DHCP is enabled and an IP address is not configured.
The M-ATA must be power cycled or reloaded after changing any of the network settings. Menu selection item
Network Status
will not reflect setting changes until after M-ATA is reloaded or power cycled.
Note
Configuration of these settings can result in loss of connectivity to the M-ATA on the local LAN.
B.1 Accessing the voice prompt
Dial
****
from the analog handset to reach the main menu.
B.2 Existing voice prompt configuration
On hook the analog phone.
Access
Code
Main Menu
Selection
Announcement/Function
Voice Prompt
User input
****
Main Menu
Plays main menu selections
SmartLink Configuration
Main Menu
Enter selection code
100#
Network status
Plays DHCP setting, IP address,
gateway IP address and IP net-
work mask setting
100# Network status
None.
110#
DHCP setting
Enables or Disables DHCP
110# DHCP Settings
1# to enable DHCP
2# to disable DHCP or “#” to return
to the main menu
120#
IP address setting Sets IP address of
the M-ATA
120# Set IP Address
Use “*” to instead of .“.”, and “#”
to end.
Ex: 172*16*230*227# or “#” to
return to the main menu
130#
Gateway setting
Sets the gateway router IP
address
130# Set gateway router
IP address
Use “*” to instant of “.”, and “#” to
end or “#” to return to the main
menu
140#
Net mask setting
Set the IP network mask
140# Set IP
network mask
Use “*” to instant of “.”, and “#” to
end or “#” to return to the main
menu
150#
Reload
Immediately reloads
the SmartLink
None
None
