2
SIPxNano Quick Start Guide
3.0 Before you begin
Note
The NanoServ chassis is within thermal and design limits but it does run warm. For proper operation
and cooling the system must have 2 cm or 1 inch of space for pen air around both side vents. In other
words, it cannot be laid down flat on a table, and it cannot be standing flat against a partition, etc.. If
mounted in some place, it must be mounted with stand off space about 1 inch. If mounted in a closed
enclosure, it will need 1 or 2 fans on the outer enclosure for proper air flow inside.
Before you turn on the SIPxNano, follow these steps (see figure 1):
1.
Place the SIPxNano upright in the metal stand (included).
2.
Attach a VGA monitor (not included) into the VGA port on the rear panel.
3.
Attach the keyboard (not included) into the PS/2 port on the rear panel.
4.
Attach the mouse (not included) into the second PS/2 port on the rear panel.
5.
Attach the Ethernet cable (not included) into the RJ-45 port and connect the other end to the PC (not
included).
6.
Attach the power adapter (included), and plug it into the closest electrical outlet.
7.
Turn on the power switch on the rear panel.
Figure 1.
Rear panel of the SIPxNano
POWER SW
DC-IN 5V
COM1
Audio Line-Out
Mic-In
Serial Port **
VGA Port
RJ-45 10/100 Ethernet Jack
USB Port
PS/2 Mouse (6-pin)
Parallel Port **
PS/2 Keyboard & Mouse (6-pin)
DC Power Jack (3-pin)
Power supply switch
** This feature is only
available for Model 6075.
