Patton electronics Patton SmartLink M-ATA, Руководство по началу работы

Страница: 86 / 86

Introduction
86
SmartLink M-ATA Getting Started Guide
E • Voice prompt configuration
Introduction
The M-ATA provides the ability to review and set the network configuration parameters using the handset of
an attached analog telephone handset.
By default from the factory, DHCP is enabled and an IP address is not configured.
The M-ATA must be power cycled or reloaded after changing any of the network settings. Menu selection item
Network Status will not reflect setting changes until after M-ATA is reloaded or power cycled.
Note
Configuration of these settings can result in loss of connectivity to the M-
ATA on the local LAN.
Accessing the voice prompt
Dial **** from the analog handset to reach the main menu.
Existing voice prompt configuration
On hook the analog phone.
Access
Code
Main Menu
Selection
Announcement/
Function
Voice Prompt User input
**** Main Menu Plays main
menu selections Patton SmartLink Con-
figuration Main Menu Enter selection code
100# Network status Plays DHCP setting, IP
address, gateway IP
address and IP network
mask setting
100# Network status None.
110# DHCP setting Enables or
Disables DHCP
110# DHCP Settings 1# to enable DHCP
2# to disable DHCP or “#” to
return to the main menu
120# IP address
setting
Sets IP address of
the M-ATA 120# Set IP Address Use “*” to instead of “.”, and
“#” to end.
Ex: 172*16*230*227# or
“#” to return to the main
menu
130# Gateway
setting
Sets the gateway router IP
address 130# Set gateway
router IP address Use “*” to instant of “.”, and
“#” to end or “#” to return to
the main menu
140# Net mask
setting
Set the IP network mask 140# Set IP
network mask Use “*” to instant of “.”, and
“#” to end or “#” to return to
the main menu
150# Reload Immediately reloads
the SmartLink None None