EnviroNET Quick Start Guide
3
2.0 Wiring the power
2.1 Running the power cable through the gland
To run the power cable through the gland:
1.
Locate the gland that the power cable should be run through.
2.
You may unscrew the gland to allow more flexibility when threading the power cable wires. To unscrew
the gland, either by hand or with a Crescent® (adjustable) wrench, turn the gland to the left until it is
loosened.
3.
Carefully thread the wires through the gland from the outside into the EnviroNET.
Note
The brass glands on the bottom panel of the EnviroNET can properly seal cables with an outer diameter
between 3mm and 8mm.
2.2 Connecting the power cable wires to the EnviroNET
To connect the power cable wires to the EnviroNET:
1.
Run the power cable wires from outside of the EnviroNET through the unscrewed gland (on the far left) to
the inside of the unit.
2.
Connect the power cable wires to the external power connection block that is labeled,
E N L
, as described
in
table 1
.
3.
Be sure to leave a little slack on the wires so that they are not stressed or pulled too tightly. Also, make
sure that the power cable wires are secured tightly in the
E N L
block.
4.
To ensure that the cables are properly secured in the gland, tighten the gland by turning the loose pieces
all the way to the right using a Crescent® (adjustable) wrench.
Table 1.
Power cable wires
Designated Slot
Power Wire (Color)
Earth (E)
Green
Neutral (N)
White
Line (L)
Black
AC IN
100-240V
0.15A
50/60Hz
POWER
BLOCK
DC OUT
12V/0.42A
PWB-5002
E
N
L
