18
5.0 OPERATION
Once the CopperLink Ethernet Extenders are properly installed, they
should operate transparently. No user settings required. This section
describes reading the LED status monitors.
5.1 POWER UP
Before applying power to the CopperLink Ethernet Extender, please
review section 3.5, “Connecting Power” on page 15 to verify that the unit
is connected to the appropriate power source.
5.2 FRONT PANEL LED STATUS MONITORS
The CopperLink Ethernet Extender features seven front panel LEDs (five
on the rack card) that monitor power, the Ethernet signals, and the Cop-
perLink connection. Figure 10 shows the front panel LEDs. Table 4 on
page 19 describes the LED functions for the model.
Figure 10.
CopperLink Ethernet Extender unit front panel
There are no user-serviceable parts in the CopperLink Ethernet
Extender. Fuse replacement should only be performed by quali-
fied service personnel. Contact Patton Electronics Technical sup-
port at (301) 975-1007 for more information.
WARNING
Power
LED
CopperLink
Link LED
Ethernet
Link LED
Ethernet
Collision LED
Ethernet
Fdx LED
CopperLink
QOL LED
Ethernet
100M LED
Co
pp
erL
ink
™
Eth
er
ne
t E
xte
nd
er
CopperLink
Fdx
