10
3.0 INSTALLATION
Because the CopperLink-T T1/E1 Extenders require no configuration, they
can be installed quickly. Installation consists of the following:
• Connect the power plug (refer to section 3.1, “Connecting Power” on
page 11).
• Connect the line port (refer to section 3.3, “Connecting the Line Port”
on page 12)
Note
See Figure 1 and Figure 2 for the rear-panel connectors
locations.
• Connect the serial port (refer to section 3.4, “Connecting the Circuit
Interface” on page 12).
Figure 1.
CopperLink-T Model 2113 rear panel
Figure 2.
CopperLink-T Model 2115 rear panel
Made in the USA
Power
Power
Line
Line
TX
Interface
RX
RX (75 Ohm)
(Data
from
G.703/G.704
network)
TX (75 Ohm)
(Data
to
G.703/G.704
network)
E1 interface
(120 Ohm)
Made in the USA
Power
Power
Line
Line
Interface
T1 interface
(RJ-48C)