Patton electronics 1205RC, Руководство пользователя

Страница: 8 / 20

JP2: Carrier Control (Port A)
The setting for jumper JP2 determines–with respect to Port A–
whether the Model 1205RC’s carrier is “constantly on” or “controlled
by RTS”.
JP2 Setting
Position 1&2 Carrier “Constantly ON” (factory default)
Position 2&3 Carrier “Controlled by RTS”
Strap Removed Not a valid setting
JP3: Carrier Control (Port B)
The setting for jumper JP3 determines–with respect to Port B–
whether the Model 1205RC’s carrier is “constantly on” or “controlled
by RTS”.
JP3 Setting
Position 1&2 Carrier “Controlled by RTS”
Position 2&3 Carrier “Constantly ON” (factory default)
Strap Removed Not a valid setting
JP5: Clock Source (Port A)
The setting for jumper JP5 determines–with respect to Port A–
whether clocking is internal or external. Note: Only Port A may be set
for external clock.
JP5 (Port A) Setting
Position 1&2 External Clock
Position 2&3 Internal Clock (factory default)
Strap Removed Not a valid setting
JP4: Clock Source (Port B)
The setting for jumper JP4 determines–with respect to Port B–
whether clocking is internal or receive loopback. Note 1 : If Port B is set
for receive loopback clock, Port A must be set for external clock.
Note
2 : Port B may not be set for external clock.
JP4 (Port B) Setting
Position 1&2 Receive Loopback Clock
Position 2&3 Internal Clock (factory default)
Strap Removed Not a valid setting
7
Switching the Power Supply On and Off
The power supply on/off switch is located on the front panel.
When plugged in and switched on, a red front panel LED will glow.
Since the Model 1000R16 is a “hot swappable” rack,
it is not necessary
for any cards to be installed before switching on the power supply .
The power supply may be switched off at any time without harming the
installed cards.
NOTE: Please refer to the Model 1000RP Series User Manual AC
and DC Rack Mount Power Supplie s for fuse and power card
replacement information.
4.2 INSTALLING THE MODEL 1205RC INTO THE CHASSIS
The Model 1205RC is comprised of a front card and a rear card.
The two cards meet inside the rack chassis and plug into each other by
way of mating 50 pin card edge connectors. Use the following steps
as a guideline for installing each Model 1205RC into the rack chassis:
1. Slide the rear card into the back of the chassis along the
metal rails provided.
2. Secure the rear card using the metal screws provided.
3. Slide the card into the front of the chassis. It should meet the
rear card when it’s almost all the way into the chassis.
4. Push the front card gently into the card-edge receptacle of the
rear card. It should “click” into place.
5. Secure the front card using the thumb screws.
NOTE: Since the Model 1000R16 chassis allows “hot swapping”
of cards, it is not necessary to power down the rack when you
install or remove a Model 1205RC.
10