EN
118
EN
119
bit.
Fragments of metal from the bit could
dislodge and strike you or bystanders.
h)
Never place the tool down until the bit or
accessory has come to a complete stop.
Do not use dull or damaged bits and ac-
cessories.
Dull or damaged bits have a
greater tendency to bind in the workpiece.
i)
When removing the bit from the tool
avoid contact with skin and use proper
protective gloves when grasping the bit
or accessory.
Accessories may be hot after
prolonged use.
j)
Do not run the tool while carrying it at
your side.
The spinning drill bit may be-
come entangled with clothing and injury
may result.
k)
Brace the tool properly before use.
This
tool produces a high output torque and
without properly bracing the tool during op-
eration loss of control may occur resulting in
personal injury.
l)
Wear dust mask for protection of your
respiratory tract.
m)
Make sure your workpiece can not slip.
If necessary, secure the workpiece with
clamps.
II. Safety instructions when using long
drill bits
a)
Never operate at higher speed than the
maximum speed rating of the drill bit.
At
higher speeds, the bit is likely to bend if al-
lowed to rotate freely without contacting the
workpiece, resulting in personal injury.
b)
Always start drilling at low speed and
with the bit tip in contact with the work-
piece.
At higher speeds, the bit is likely to
bend if allowed to rotate freely without con-
tacting the workpiece, resulting in personal
injury.
c)
Apply pressure only in direct line with
the bit and do not apply excessive pres-
sure.
Bits can bend causing breakage or
loss of control, resulting in personal injury.
Declaration of conformity
We declare, that the product
described in
Technical Data
:
1050 W Rotary hammer PDH26DS2
manufactured for:
HORNBACH Baumarkt AG
Hornbachstraße 11
76879 Bornheim / Germany
is in conformity with the following directives:
Machinery Directive 2006/42/EC
EMC Directive 2014/30/EU
RoHS Directive 2011/65/EU
and in accordance to the following applicable
harmonized standards:
EN 60745-1:2009+A11
EN 60745-2-6:2010
EN 55014-1:2006+A1+A2
EN 55014-1:2017
EN 55014-2:2015
EN 61000-3-2:2014
EN 61000-3-3:2013
Andreas Back
Head of Quality Management, environment &
CSR
Person authorised to compile the technical file
Bornheim, 8.3.2021
HORNBACH Baumarkt AG
Hornbachstraße 11
76879 Bornheim / Germany
