Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
Operating instructions for the hand-
held plane
MACHINE DESCRIPTION
1
Knob for setting the planing depth
2
ON/OFF switch
3
Safety lock-off
4
Rear baseplate
5
Belt guard
6
Front baseplate
7
Chip outlet
8
Dust bag
9
Accessory parallel stop
10
Accessory for setting the depth of step
Proper use
The electric hand-held plane is for the planing,
rebating and chamfering of wooden parts.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
POWER SUPPLY
Before using your machine for the first time, make
sure your power supply is the same as that specified
on the type plate. Under no circumstances should
your power supply exceed that specified by more
than 10%.
SWITCH
The electric hand-held plane is equipped with a
safety switch to prevent accidents. To switch the
machine on, press the lock-off button on the side of
the machine and then press the ON switch. To
switch off the hand-held plane, release the ON
switch, which will then jump back to its starting
position.
Dust extraction (Fig. 2)
For an optimal dust extraction you can fit the dust
bag (8) supplied. To do so, slide the dust bag (8) into
the dust outlet (7) on the side of the electric hand
plane.
USING THE MACHINE
Important: The electric hand-held plane must be
switched on before coming into contact with the
workpiece.
Setting the planing depth
The planing depth can be set between 0 and 3 mm
by turning the setting and guide knob to the left or
right.
When you have finished working with the plane, set
the planing depth so that the knife is lowered and
protected against damage.
Planing flat surfaces
Set the desired planing depth. Place the front
baseplate of the electric hand-held plane on the
workpiece and switch it on. Holding the plane in both
hands, slide it over the surface, making sure both the
front and rear baseplates are lying flat on the
workpiece.
To finish the planed surface, set a very low planing
depth and rework the planed surface as often as
necessary.
Chamfering edges (45°)
GB
8
Anleitung E-HO 900_SPK7:_ 13.12.2007 9:15 Uhr Seite 8
