Patron TOM 5, Инструкция по применению

Страница: 8 / 36

8
stroller carefully. Attach the safety bar and adjust the footrest position. Pull on and adjust all fixation and position-
ing accessories the stroller is equipped with. Always make sure that the child is seated comfortable in the stroller.
Getting out of the stroller:
Engage parking brake. If necessary ask trustful person for help to hold the stroller firmly. If required to easy getting
out of the stroller adjust footrest position Take off all applied fixation and positioning accessories. Take off the
safety bar and get the child carefully out of the stroller.
Getting over the curb stones and low obstacles:
Down - Drive the front wheels to the edge of the curb. Hold the handles firmly and tip the stroller backwards and
balance on the rear wheels. Drive the rear wheels to the edge of the curb, lower the stroller down the curb slowly on
its rear wheels.
Up - Drive the front wheels close to the curb. NEVER bump the front wheels into the curb stone!. Hold the handles
firmly and tip the stroller backwards and balance on the rear wheels. Drive forward and place the front wheels on
top of the kerb. Position the rear wheels at the curb tone bottom edge and lift to the upper level.
Manual transport of the stroller:
- make use of ramps and lifts when they are available
- if there is no alternative and steps should not be avoided at least one trustful assisting person must be available to
give assistance
- do not attempt to take the stroller up or down over the number of steps unless you and your assisting person are
not sure to have the full control during the manipulation as well as he or she can absorb the weight of its occupant
and stroller.
- take the rests in regular intervals, if you are tired
- occupant hands must be inside the seat unit during the manual transport time
- NEVER lift the stroller holding the safety bar or footrest!
Going stairs downwards:
Tightly hold the handle and position the stroller squarely with the front wheels on the top step. Tip the handle back-
ward and push the stroller forward until the rear wheels are at the end of top step. Assisting person stands in front,
holding the stroller by gripping the front frame. Lift the stroller by both persons at once. Carry the stroller down the
steps. Continue step by step to the bottom surface (pic.15).
Going stairs upwards:
Tightly hold the handle and position the stroller squarely with the rear wheels against the bottom step. Tip the han-
dle backward and push the stroller forward until the rear wheels are at the end of bottom step. Assisting person
stands in front of stroller, holding the stroller by gripping the front frame. Lift the stroller by both persons at once.
Carry the stroller upstairs. Continue step by step to the top surface (pic.15).
Upholstery:
Seat upholstery is fully detachable and hand washable by lower temperature (max. 40°C).
Backrest cover – put on the cover top part over the upper part of backrest, cover the front part, slip the cover into
the gap between the backrest and seat base. Secure the lower end of cover by velcro fastener at the back of the
backrest.
Seat base cover – put on the covers of the seat base side panels one by one, place the cover in correct position onto
the seat base and cover by overlapping parts the side panels, fix by dry zipper.
4) Standard equipment
Padded frame cover:
Attaching – put on the frame sides and connect the zipper. Pull over the locking mechanism (left side). Pull over the
locking mechanism and tilt adjusting lever (27, pic.13) (right side). Close both zippers fully till the upper end.
Detaching – unzip both zippers and take off padded frame covers (when folding the stroller just unzip the covers
partly from top and then pull over the locking mechanism upwards).
Hip rest:
Attaching – mount the hip rest by plastic clip onto the vertical side tubes of the backrest (28, pic.13).
Detaching – fold the hip rest inside the backrest and release the plastic clip from the side tube.
Basket below the stroller :
Attaching – Attach the baskets centre part over the undercarriage middle cross bar using fasteners. Fix it with the
poppers. Attach the baskets rear part, interlace the fasteners through the side loops placed on the rear frame profiles.
Fix it with the poppers. Attach the baskets front part over the undercarriage front curved cross bar using fasteners.
Fix it with the poppers (pic.12).
Detaching – unfasten and release all fasteners from the anchoring points.
Transport safety catch:
Attaching – pull the transport safety catch fastener around the connecting bar and front frame vertical tube. Interlace
the fastener through the loop and fix it with the popper. (pic.14).
Detaching – unfasten and release the fastener.
5) Optional equipment:
This product can be optionally supplied with very wide range of fixation and positional accessory. Please find the
optional accessory user guide as separate brochure.