9
OPERATING INSTRUCTIONS
1
2
LED Indicator
High Speed
Medium Speed
Low Speed
Fan Off
Light Delay
Light Control
Reverse Switch
D/O Switch
Battery Compartment
(battery door removed)
2. Remove battery door from back of the remote, from
remote pack, to access the following:
D/O Switch
- set to “D” at the factory. The switch should
remain in the “D” position to ensure the LED board is
dimmable.
LEARN
- Syncs remote to receiver (see
TROUBLESHOOTING for instructions).
1. To operate the fan using the remote, press and release
the following buttons:
III
- High speed
II
- Medium speed
I
- Low speed
Fan Off
- Turns power to fan off.
Light Delay
- Tap the Light Delay button, which will turn
off the light after one minute. Tap the Light Control button
to exit Light Delay mode.
Light Control
- Tap the Light Control button to turn the
light off and on. Press and hold Light Control button to
dim or brighten the lights.
Reverse Switch
-
In warmer weather,
push the Reverse
Switch left toward sun icon, which will result in downward
airflow creating a wind chill effect.
In cooler weather,
push the Reverse Switch right toward
the snowflake icon, which will result in upward airflow
that can help move hot air off the ceiling.
Important:
Wait for the fan to stop before moving the
Reverse Switch. The Reverse Switch must be set either
completely left or right in order for the fan to function
correctly. If the switch is set in the middle position, the fan
will not operate.
Low Battery Indicator
- LED Indicator will flash for one
minute as a reminder to replace the 12-volt battery.
