Page 4 of 8
211019
ASSEMBLY INSTRUCTIONS (continued)
ASSEMBLY INSTRUCTIONS (continued)
Sensitivity of Motion Sensor:
1. You can adjust the sensitivity of the motion sensor by using the “Sens” selector
located on the bottom surface of the sensor. (See Fig.5)
2. Adjust motion sensor sensitivity to HIGH (H), MEDIUM (M), or LOW (L) to
achieve desired performance.
3. Approximate range for each setting: 30 ft. (L), 50 ft. (M), 70 ft. (H).
Fig. 5
FUNCTION AND OPERATION
Adjusting the Light Head:
1. Gently grasp the light heads (B) and tilt them up or down, left or right to
adjust the light coverage area.
Keep the light heads (B) at least 1” (25mm) away from the sensor.
(See Fig. 4)
2. Keep the light heads (B) 30˚ below horizontal to avoid water damage and
electrical shock.
MODE
TIME
Auto
Link
L
M
H
Test
30s
1min
3min
PC
3H
SENS
Custom
Choose a mode by sliding the switch on the bottom of the sensor. (See Fig.5)
Note: When power is first applied, the light will turn on to 100% brightness.
The sensor will take 30 seconds to warm up.
1.
TEST MODE (daytime and nighttime operation.)
● Slide the Time switch the “Test” position.
● The light turns to high-level brightness (5000K) when motion is detected, and stays on as long as the motion
continues.
Then it revert back to 2700K CCT Color and the low-level brightness (0~50%) as per setting about 5 seconds
after motion is no longer detected.
2.
AUTO MODE (nighttime operation only)
● To “AUTO” mode,
slide
the
Time switch to the desired time setting
(30s/1min/3min). At dusk, the light turns on to pre-selected low-level
brightness (2700K). When motion is detected, the light turns to high-level
brightness (5000K) and stays on as long as motion continues. When the
motion is no longer detected, the light at high-level brightness (5000K)
remains on for the predetermined time you set (30s/1min/3min), then
switches back to pre-selected low-level brightness (2700K) automatically.
● The light turns off automatically at dawn.
Note: You can adjust the low-level brightness(0~50%) by using the low-level brightness(0~50%) knob on
the backplate (See Fig.6).
3.
PC MODE (nighttime operation only)
● In "PC" mode, the light will turn on at full brightness (5000K) at dusk and remains on until dawn.
4.
3 HOURS (3H) MODE (nighttime operation only)
● In “3H” mode, the light turns to high-level brightness (5000K) at dusk, and stays "ON" for 3 hours, then it turns to
pre-selected low-level brightness (2700K). It turns to high-level brightness (5000K) when motion is detected, and
stays on as long as motion continues. When motion is no longer detected, it remains on for the predetermined
shut-off delay time you set (30s/1min/3min), then returns to the pre-selected low-level brightness (2700K)
automatically.
● The light turns off automatically at dawn.
Note: You can adjust the low-level brightness(0~50%) by using the low-level brightness(0~50%) knob on
the backplate (See Fig.6).
B
Fig. 4
Low Level
0%
50%
Fig. 6
