Page 3 of 4
5. Remove the four bolt nuts and the
four small rubber pads from the
metal frame (C). Attach the metal
frame (C) to the dome (D) by
aligning and inserting the threaded
rod on the metal frame (C) into the
open holes on the dome (D), then
place the four small rubber pads
over the exposed threaded rod
before screwing the four bolt nuts.
A
C
D
5
Bolt nut
Threaded
Rod
Small
Rubber
Pad
190724
ASSEMBLY INSTRUCTIONS (continued)
Turn on the power at fuse or circuit box.
6
CC
AA
1
6. Pull out the source wires from the
outlet box. Make wire connections
using wire connectors (CC) as
follows:
• Connect the hot wire (usually
black insulation) from the fixture
to the black wire from the power
source.
• Connect the neutral wire (usually white insulation) from
the fixture to the white wire from the power source.
• Attach the fixture grounding wire (usually green
insulation or bare wire) to the cross bar unit (AA) with
the green grounding screw, then connect it to the
house grounding wire with the wire connector (CC).
Carefully put all of the wires back into the outlet box.
Spare Parts List:
Assembly Kit
5393MM (1 SET)
B
Glass Shade
X1
9735CS
Mounting Strap Unit
X1
Mounting Screw
X2
Wire Connector
X3
End Cap
X1
Rubber Pad
X1
AA
BB
CC
DD
EE
The following parts are available for reorder if damaged or missing. Call our toll free at 1-800-887-6326.
DD
EE
7
AA
A
Threaded Pipe
FF
8W Type A LED Bulb
(
included
)
X1
8107LED
7. Attach the backplate (A) of the
fixture to the mounting strap unit
(AA) by aligning and inserting the
threaded pipe from the mounting
strap unit (AA) into the open hole
on the backplate (A), then place the
rubber pad (EE) over the exposed
threaded pipe before screwing
the
end cap (DD)
.
Note: With silicone caulking compound, caulk
completely around where the backplate meets with
the wall surface to prevent water from seeping into
the outlet box.
Green Grounding
Screw
