Page 3 / 6
150619
Sensor Adjustment Lower For Short Coverage
Sensor Adjustment Higher For Long Coverage
Fig. 6
Fig. 5
Fig. 3
Fig. 4
Adjusting the Light Head:
1. Gently grasp the light heads and tilt them left or right, up or down by loosing the set screw in joint arm of sensor to
adjust the light coverage area. Keep the light heads at least 1” (25mm) away from the sensor. (See Fig. 6)
2.
Keep the light heads 30˚ below horizontal to avoid water damage and electrical shock.
Sensitivity of Motion Sensor
● You can adjust the sensitivity of the motion sensor by using the “SENSITIVITY” selector located on the right
side of the bottom surface of the sensor. (See Fig. 5)
● Adjust motion sensor sensitivity to achieve desired performance.
● Approximate range for each setting from 10ft to 70ft.
Function and Operation
Choose a mode by sliding the switch on the bottom of the sensor of the fixture. (See Fig.5 )
Note: When power is first applied, the light will turn on immediately. Wait for 30 seconds to allow the sensor
to warm up.
1.
TEST MODE (daytime and nighttime operation.)
●
Rotate
Time knob arrow on the bottom of the sensor head to the “TEST” position .
● When slide the mode selector to “OFF”, the light turn
s
off automatically. It turns to high-level brightness
when motion is detected, and stays on as long as the motion continues. It turns off about 5 seconds after
motion is no longer detected.
sensor
Adjusting the Sensor Head:
1. Aim sensor head toward desired detection area, maintaining a
5° - 40° downward angle to allow moisture to drain.
Note: Make sure sensor head is positioned with controls facing
toward the ground.
2. You can move the sensor head up and down to change the coverage
area. (See Fig. 2)
Note: Range set too high may increase false triggering.
(See Fig. 3 and Fig. 4 )
Fig. 2
Set Screw
