Flushmount
1.1
Find a location on the deck where you want to mount
the light.
1.2
Place it over the deck and use a sharp object or pen to mark
where you are going to put the screws.
1.3
Place the screws 3 in. apart in the deck and mount the light on
the screws using the brackets at the back of the light.
1.
Installing the light fixture
2.
Run the Landscape Wire (Not Included)
The landscape wire should run from the power pack to each light without being cut. Do not run the landscape
wire within 10 feet (3m) of a pool, spa or fountain. If the landscape wire is too long, cut it with a cable cutter.
The landscape wire should be protected by routing it close to proximity of the light fixture or next to a
building, deck or fence. Use cable suitable for low voltage landscape lighting.
See chart below for recommended cable gauges.
*Suitable cable should be sized in accordance to the table, should be Type SPT-2W. If you cannot find this cable at your local hardware or home improvement store then
please call customer service at 1-888-867-6095 or e-mail at [email protected] to order the cable needed.
Combined wattage of all fixtures on line (in
Watts)
Wire Gage (0-75') Wire Gage (75'-150')
Wire Gage (150'-250')
0-60
18
16
14
60-120
16
14
12
120-180
14
12
12
180-240
12
12
Not recommended
240-300
12
Not recommended
Not recommended
* llustration of fixture is for example only.
There are two ways of installing this deck light:
Hidden wire
1.1
Drill a 1” hole in the chosen location.
1.2
Use the two (2) provided screws and screw them 3in. apart
in the deck. Close enough to the hole to be able to hide it entirely
with the stair light’s body.
1.3
Pass the wire and the connector through the hole.
1.4
Mount the light on the screws.
Fixtures
Cable
Power Pack
Option 2
Option 1
Screws
Wire
Connector
Light
