Model PWREP RM P8
DMX Repeater
Manual
08/27/21
© 2021 Acuity Brands, Inc. • One Lithonia Way, Conyers GA 30012
Pathway Connectivity | #103 - 1439 17th Ave SE Calgary, AB Canada T2G 1J9
Phone: + 1 866 617 3074 www.pathwayconnect.com
• 100-240VAC 50/60Hz wide-range power input
• 0.08A maximum power consumption
•
3000V opto-isolation between DMX data links
• 250V fault protection on DMX ports
•
Star wiring is permitted only in conjunction with a repeater
•
All cabling must be a continuous daisy-chain. No “tees” are
permitted
•
Cable shield is earth-grounded at one end only, preferably at the
control console
•
Maximum length of one cable segment is 1,800 ft. (550m)
•
The last DMX device on the line must be terminated with a 100
or 120Ω resistor between pins 2 and 3
•
Cable must be Belden 9842 (120Ω), 9829, 9729 (100Ω), ISO/
IEC 11801 (Cat5) or equivalent
•
Keep all DMX cabling away from high voltage or power cables
to maintain data integrity
When equipped with 5-pin XLR connectors, this product complies
with the current ANSI E1.11 DMX512-A standard and all previous
standards to DMX512 (1990).
Screw terminal connector and RJ45-equipped models are compliant
with E1.11 DMX512-A under the non-compatible connector (NCC)
provision. RJ45-equipped models are intended for installation in
restricted-access equipment rooms and should not be used as
portable gear. Accidental connection to data switching or other
equipment may cause damage to equipment and/or personal injury.
All DMX ports are protected to 250V with self-healing circuitry.
PWREP RM P8 NONRDMs are intended for desktop use, or may
be mounted in a standard 19” equipment rack, using the rack ear
kit included.
Truss-mount adaptors (PWACC TMLG) and wall-mount adaptors
(PWACC WMLG) are also available.
The PWREP RM P8 NONRDM is intended for installation in a dry,
indoor location. Operating conditions:
14°F-122°F (-10°C to 50°C);
5-95% relative humidity, non-condensing.
Warning:
The AC socket outlet shall be installed near the
equipment and shall be easily accessible.
Warning:
This equipment relies upon building installation primary
overcurrent protection.
Warning:
Except for the IEC chassis plug marked for AC input,
all ports on the PWREP RM P8 NONRDM are intended for
low voltage data lines only. Attaching anything other than low
voltage sources to the data ports may result in severe equipment
damage, personal injury or death.
DMX BASICS
DMX512-A COMPLIANCE
INSTALLATION
•
ANSI E1.11 DMX512-A R2013
• UL
•
RoHS 2011/65/EU + A1 2015/863
• CE
COMPLIANCE
• 5.2 lbs (2.4 kg)
•
17”W x 1.7”H x 7”D (432mm x 43mm x 178mm)
• Operating Conditions: 14°F-122°F (-10°C to 50°C); 5-95%
relative humidity, non-condensing
PHYISCAL
ELECTRICAL INFORMATION
