MODEL 7150 16-CHANNEL RJ45 RS-232 A/B SWITCH WITH AUTOMATIC FALLBACK, GUI, AND
CASCADE
Electro Standards Laboratories, Inc.
(401) 943-1164
www.electrostandards.com - pg 7 - Pub. 6026-02
INSTALLATION
This section describes the physical connections required to start
operating the Model 7150.
Figure 1: Model 7150 Rear Panel
The rear panel view of the switch is shown in the above figure. On the
rear of the switch are the following ports:
•
POWER
– Phoenix (F), External Power Supply Input connector.
•
REMOTE
– RJ45 (F), 10/100BASE-T LAN access Ethernet
Remote Control port.
•
CASCADE:
o
IN – RJ45 (F), the cascade port in from previous unit.
o
OUT – RJ45 (F), the cascade port out to next unit.
•
COM
– RJ45 (F) connector, the “COMMON” or shared device
port, for each channel.
•
A
– RJ45 (F) connector, the “A” device port, for each channel
•
B
– RJ45 (F) connector, the “B” device port, for each channel.
Power Supply
After all the proper connections have been made, plug the Model 7150
into a 100VAC/240VAC, 50Hz/60Hz wall receptacle using the supplied
12VDC, 1500mA, UL listed and LPS approved, 2-prong US non-
polarized NEMA 1-15P plug wall mount power supply, P/N 517277.
Option: Wide Range Power Module, (Cat. No. 517277),
100VAC/240VAC, 50Hz/60Hz, IEC 60320 C14 inlet, can be ordered for
use in place of the standard NEMA 1-15P plug power module that is
included with the unit. Ideal for international applications.
Model 7150 Rear Panel
A, B, and COM ports
Remote
Power
Cascade In &
Out ports