Setting and Using a Guidance Line
Finishing a Job
To complete a field boundary map or guidance job to start a new one, press the
Menu
button and then
Next Job
to do a different job with the same settings or
Finished Job
to return to the Start menu.
To power off the BlackBox press
Shutdown
, then press
Yes
and disconnect from
power supply.
1) Position the vehicle in the field where the job will begin. (When using a curved
line it is important to use the longer edge of the field to set a guide line).
2) At the beginning of a straight run press
the
Grid area
to set point A.
3) Drive to the end of the run and press
the
Grid area
to set B. The guidance line
will appear ready for guidance.
4) If working the headland pass, continue
around then line up to the set AB line and
use the guidance to work the inner areas of
the field.
5) When turning in the headland the next
AB line will appear.
N.B.
The green coverage recording can be turned off and on using the ‘Recording
On/Off’ button or selected method.
PWdoc0061 v1.0
Pressing the
Grid area
a third time allows the guidance line to be reset and also if
using the ‘Straight’ guidance mode, recalibrated to align with current location.
Grid
area
Grid
area
