1
3.7 RESET/ACK function
The
RESET/ACK
key has multiple functions depending on the status of the system:
Message RESET (RESET function)
• ALL-CALL: When there is an on-going alarm and with the station in the emergency mode, hold the
RESET/ACK
key
down for 2 seconds. This will enable the messages to be stopped, although the system will remain in an emergency
status.
• PARTIAL: when there is an on-going alarm and with the station in the emergency mode, select the zones to be
muted and hold the
RESET/ACK
key down for 2 seconds.
Resetting the failure acknowledgement buzzer (ACK function)
•
In the event of failures with the station on stand-by, press the
RESET/ACK
key briefly. The buzzer will be reset only
on the actual base, while the LEDs corresponding to the failure in question will remain ON.
•
In the event of failures, press the
EMERGENCY
key to enter the emergency mode. Then press the RESET/ACK key
briefly. The buzzer will be reset on all the devices of the system. The LEDs referred to the failure in question will in
any case remain ON.
3.6 AUX function
The AUX function can be used to call up a specific combination
of messages/broadcasting zones set previously via the PA8506-V.
To do this,
enter the emergency mode
(Fig. 3.1.1), then press the
AUX
key.
The green
AUX
LED will light up to confirm activation. The red
ALARM
LED and those indicating the type of message sent (ALERT
or EVAC) will light up to indicate the existing alarm.
If a
PMB132/12-V
station is used, the LEDs referred to the zones
concerned will also light up.
Once the messages have been sent out, press
EMERGENCY
again to
leave the emergency mode, then close the cover again.
Fig. 3.6.1
