PAGE 7
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE
Soundcaster
®
PROFESSIONAL AUDIO & SOUND
®
Before operation, please check and make sure that
transmitter & receiver are of matching frequency or fre-
quency group (for PLL version). For PLL version, fur-
ther verify that the channel selected at both ends are of
the same.
To switch on the microphone, put the switch to "ON"
position. The GREEN LED will indicate that the battery
is fresh. When RED LED is on it indicates that the bat-
tery is weak and needs replacement.
For best results, an alkaline battery is recommended.
Please remove the battery if the transmitter is not to be
used for longer periods of time.
For close singing or speaking, put the sensitivity
switch to N (Normal). For stage applications, where the
speaker stands away from the microphone, put the
sensitivity switch to H (High). Speaking loudly and
closely into the microphone in the high sensitivity
position may cause output distortion.
When holding the microphone, do not cover the end of
the unit. This is where the antenna assembly is located
and transmission efficiency may be effected.
WIRELESS MICROPHONE OPERATION PROCEDURE
MW165U uses a 9V battery for power. To change
or replace the battery, remove the antenna cap
first, then press the bottom of battery compart-
ment to release the cover as shown in the figure
below.
OPERATING INSTRUCTIONS
BATTERY INSTALLATION
RECEIVER MODULE INSTALLATION
To install an additional receiver module, first
remove the two screws from the blank panel that
covers the module compartment. Position the
module so that it will exactly slide into the guide
rails within the compartment, push in the module
so that the gold contact connector plugs firmly
into the rear socket. To secure the receiver mod-
ule to the WPSS100 rear panel, tighten the
receiver panel with two screws.
RF
RF
A
A
B
B
AF
AF
POWER
POWER
POWER/MIN
POWER/MIN
MAX
MAX
CH
CH
PLL DIVERSITY RECEIVER
PLL DIVERSITY RECEIVER
UHF
UHF
11
33
55
77
99
1111
13
13
15
15
OUT
IN
PROFESSIONAL AUDIO & SOUND
®
O
O
PORT FOR OPTIONAL PLL
UHF RECEIVER MODULE
