DESCRIPTION AND APPLICATIONS
SPECIFICATIONS
PAGE 2
© copyright Paso Sound Products, Inc. 2004
Specifications are subject to change without notice
DMA3060/3120
UNPACKING
Immediately upon receipt of the amplifier, inspect the unit
and shipping container for indications of improper handling
or in transit damage. The equipment was carefully inspect-
ed and tested before leaving the factory. Notify the
Transportation Company immediately if any damage is
found. ONLY THE CONSIGNEE CAN FILE A CLAIM WITH
THE CARRIER FOR DAMAGE DURING SHIPMENT. Be
sure to save the carton and packing material as evidence of
damage for the shipper inspection. DO NOT SHIP the unit
back to the factory unless authorized by the factory.
IN TRANSIT DAMAGES ARE NOT COVERED BY THE
PASO WARRANTY.
❑
❑
High Performance - High Reliability Design
❑
❑
Wide Frequency Response - Very Low Distortion
❑
❑
5 Channel Inputs - 2 Zone Outputs
❑
❑
Up to 3 Balanced Microphone Inputs
❑
❑
Phantom Power on all MIC Inputs
❑
❑
MIC 2/AUX 1 and MIC 3/AUX 2 Inputs
With Stereo Summing
❑
❑
AUX1 and AUX2 Inputs Attenuator
❑
❑
600 ohm Transformer Balanced
Telephone Paging Input
❑
❑
MIX Buss and 600 ohm Line Output
❑
❑
Independent Input Controls
❑
❑
AUX1 Remote Volume Controls
❑
❑
External EQ Link
❑
❑
Tone by-pass and EQ Link switches
❑
❑
Addressable VOX Buss
Voice Activated Muting
❑
❑
VOX Variable Time Delay Function
❑
❑
Addressable MUTE Buss
❑
❑
Direct Muting and Unmuting
❑
❑
600 ohm and 8 ohm 2 Watt Max.
Music on Hold Amplifier
❑
❑
MOH Amplifier Source Selector
❑
❑
Zone 2, 2 Watt - 8 ohm Output
with Separate Control
❑
❑
24 V DC 250 mA Regulated Power Supply Output
❑
❑
8 ohm, 25 Volt & 70 Volt Output
❑
❑
Optional 19” Rack Mounting with Kit
❑
❑
Low profile - 2-Unit of Vertical Rack space
❑
❑
UL 6500 Listed (US - CANADA)
PROFESSIONAL AUDIO & SOUND
®
DIGITAL MUSIC AMPLIFIERS
POWER OUTPUT:
DMA3060
60 Watt RMS
DMA3120
120 Watt RMS
Distortion:
0.01% THD at 1 kHz rated power
Frequency Response:
20 hz - 30 Khz ± 2 dB
Inputs:
Input 1
MIC Electronically Balanced,
Transformer Balanced with MT250 (optional)
Input 2
Telephone Transformer Balanced
Input 3
MIC Electronically Balanced - AUX 1 (Stereo Sum.)
Input 4
MIC Electronically Balanced - AUX 2 (Stereo Sum.)
Input 5
Module Port
Sensitivity & Z:
Input 1
Mic 1 = 1.5 Mv - 250 ohm
Input 2
Tel=100 Mv - 600 ohm - Transformer Balanced
Input 3
Mic 3 = 1.5 Mv - 250 ohm - AUX 1 = 100 Mv - 47K ohm
Input 4
Mic 4 = 1.5 Mv - 250 ohm - AUX 2 = 100 Mv - 47K ohm
Input Attenuator:
AUX 1 and AUX 2
Phantom Power:
All Microphone Inputs by internal jumper (18 V)
Hum & Noise:
Mic -70 db, Aux -75 db 600 ohm Transformer balanced
Telephone Paging Input:
600 ohm Transformer Balanced
EQ LINK:
Preamp. out, Power Amp in with EQ Link Switch
Line Output:
Line Out 600 ohm - 1.5 V loaded
Inputs/Outputs:
MIX BUSS
Zone 1 Output:
2 Watt Max. - 8 ohm with Control
Music on Hold Output:
600 ohm-1 Volt Transformer Balanced
Zone 2 Output:
2 Watt Max. - 8 ohm with Control
Main Output Impedance:
8 ohm, 25 Volt and 70 Volt line
Controls:
Front Panel:
Input 1 Volume, Input 2 Volume, Input 3 Volume,
Input 4 Volume, Module Volume, Bass and Treble
Rear Panel:
AUX 1 Attenuator - AUX 2 Attenuator, VOX1 Sensitivity,
VOX2 Sensitivity, MOH/ZONE 1 Level Control - ZONE 2
Level Control - VOX Sensitivity - MUTE Delay
Tone Controls:
Bass and Treble
± 10 dB at 100 hZ and 10 KHz
Tone By-Pass:
On - Off Switch Rear Panel
Remote Volume Control:
INPUT 3 - AUX 1
Input Volume
MOH Source Selecti:
AUX 1 and AUX 2
Zone 2 Source Select:
AUX 1 and AUX 2
VOX BUSS:
Available on all Inputs by internal Jumper
MUTE BUSS:
Available on all Inputs by internal Jumper
MUTE DELAY:
Adjustable from 3 Sec to 60 Sec (rear panel control)
Direct Muting:
M1, M2 External Contact Closure
Unmuting:
MUTES/UNMUTES MIC 1 only
Power Supply Output:
24 V DC - 250 mA Regulated
Rack Mounting:
Optional 19” Rack Kit
Internal Cooling Fan:
Thermally Controlled
Protection:
Power Surge, Overload and Thermal Protection
Power Requirement:
117 Volt, 50-60 hZ
Power Consumption:
DMA3060
= 670VA -
DMA3120
= 850VA Max.
AC Accessory Outlet:
117 v - 500 W Max. Unswitched
Terminations:
Screw Terminals, RCA Jacks
Housing Finish:
Black
Output Power Indicator:
Multi-color LED Signal and Clip
Dimensions:
10.75” W., 11” D., 4” H. with feet
(274X280X102 mm)
3.5” H
(89 mm). less feet
Net Weight:
DMA3060
= 16 Lbs
(7.3 Kg)
DMA3120
= 19 Lbs
(8.7 Kg)
