![background image](http://html1.mh-extra.com/html/paslode/ringfast-a515/ringfast-a515_product-manual_761545016.webp)
15
Problem Cause Solution
Ring spitting
Build up of material in
clinchers (021
、
022) helix,
(when using plated,
aluminum or plastic coated
rings)
Remove build up of material
Snapping noise as ring
is being fed from
magazine
Defective rings
1.Burr on outside curve of
ring
2.Rings skewed on stick
3.Rings out of line on stick
4.Rings twisted opposite to
clincher helix
5.Rings not symmetrical
6.Rings strip flare at the
ends
7.Wrong wire gauge for
model of tool
Return sample of rings to
your distributor to be tested
Too few shims under
magazine (035) (Ring is
being forced under the
shoe (027) that has
“bottomed out” and is
deflecting the magazine
(035)
Replace magazine (035)
。
Snapping noise as ring
is being fed from
magazine
Rings of wrong wire gauge
used in tool (too large)
Verify rings and use correct
rings for the given tool
Front valve’s seat (019) is
not at right position
Adjust the position of front
valve’s seat (019) (See page
22)
Worn O-ring (506)
Replace O-ring (506)
Worn O-ring (504)
Replace O-ring (504)
Worn O-ring (502)
Replace O-ring (502)
Leaking when no
fighting
Worn packing (002)
Replace packing (002)