PASIAN Flora, Руководство пользователя

Страница: 16 / 48

MANUALE UTENTE
,
USO E MANUTENZIONE
Due to a correct can system:
- Use smooth internal pipes capable of withstanding continuous temperatures above 150 ° C.
- It is forbidden to use corrugated or plastic pipes.
- It is forbidden to develop downhill sections.
- Reduce the number of curves as much as possible (maximum 4).
- To guarantee an appreciable result, it is mandatory to insulate the pipes with mineral wool
resistant to at least 150 ° C.
- Keep any flammable materials away from the duct pipes at least 20 cm.
- Any narrowing of the pipe section with respect to the outlet diameter, even partial, is
prohibited.
- It is forbidden to install some devices that can completely close the ducting.
- It is possible to carry out ducting routes up to 10 meters in total, considering each curve as
if it were 1 meter. It is possible to exclude one or both channels (use an 80 mm cap suitable
for high temperatures) (Figure 16).
- It is possible to adjust the front hot air through a lever placed on the front grille
(Figure 17).
(figura 16)
(figura 17)
It is recommended to open the front gri d if both ducts are plugged to prevent the
machine from overheating
The outlet air pipe can reach very high temperatures, even in the order of 150 ° C: it is
therefore necessary to insulate it appropriately and with suitable materials, in those
points where it can come into contact with flammable surfaces or that are affected by
temperature ( ducts for the passage of electric cables, plasterboard, etc.); it is also necessary to
protect people and animals from voluntary or accidental contact. In any case, comply with the
regulations and laws in force.
15