INSTALLATION
3. remove the plastic panel under the dashboard where is located the OBD plug. Remove the
OBD plug from its location and keep it from the wires exit view, consequently connect the can
bus wires as shown below.
Lay
down
the can bus wires of the module (Green and White) till the OBD plug, then:
Connect the GREEN wire CAN H of the module to the RED wire of the OBD position 6.
Connect the WHITE wire CAN L of the module to the BLUE wire of the OBD position 14.
We suggest to sold the wires.
Lay down the button till the gloves box passenger side or fix it near the steering wheel as shown
below.
Once
done
the connection and after a quick check restore all the parts .
When the system announces an anomaly, please immediately reduce the speed, don’t
hit the brakes and don’t steer hardly. Stop as soon as possible and control the status
of the tyres.
The user is responsible to maintain the tyre pressure in the correct ranges. Control
regularly the pressure.
Under certain circumstances such as irregular driving, winter conditions, unpaved
roads, it may happen that the module is involved in late or not at all.
2
Can H
Can L
1
8
9
16
OBD CONNECTOR
WIRES EXIT VIEW
IN CASE OF DIFFERENT COLOURS OF THE CANBUS WIRES IN THE OBD PLUG PLEASE
FOLLOW THE POSITIONS
Power feeding
+12 VDC
Consumption in work mode
1A
Consumption in sleeping mode
<3mA
Plastic box size
6.70x6.70x2.8 cm
Weight per unit
45 g
70 km/h
90 km/h
110 km/h
130 km/h
150 km/h
Disable
Once the vehicle overcomes the range set, the unit will emit a BEEP.
With the item BACK, the user can go back to the principal menu
With the item EXIT, the user can exit to the principal menu; anyway the system exits after about
20 seconds on inactivity.
INSTALLATION AND USE
Please remove the car radio.
Please connect the unit by using the available P&P cable.
Please re– connect the car radio.
Please control that the kit’s LED is switched on GREEN.
Please do a control about the functions before to re-place the car radio in its lodge.
Please re-install the car radio.
Please flat the pneumatics according to the values recommended by the manufacturer
Please do the
Recalculation of the tyres condition
To verify the function of the TPMS, please deflate the pneumatic till 0.5 bar and then drive
some kilometres.
7
