MediaDAB HD
Rev 2.15
4
POWER AND STEERING WHEEL COMMANDS CONNECTIONS
Power and steering wheel connections are located in the 22 poles connector as indicated.
Connect RED cable to the car radio 12VDC positive.
Connect BLACK cable to the ground.
Connect MediaDAB HD BLUE-YELLOW cable to a positive ignition output.
The BLUE-YELLOW wire must not be connected if the vehicle uses CANBUS or GMLAN
protocol.
Connect steering wheel interface wires in series to the OEM wires, for example in a car
that uses CANBUS protocol is necessary to cut the CAN H wire and connect GREEN wire
to the car side and GREEN/YELLOW to the radio side, the same must be done with CAN L
and WHITE and WHITE/YELLOW wires.
GND
12 VDC
POSITIVE
IGNITION
CANBUS
R-LADDER
GMLAN
POWER
ANTENNA OUTPUT
FUNCTION
CANBUS WIRES
GREEN
CAN H INPUT
WHITE
CAN L INPUT
GREEN / YELLOW
CAN H OUTPUT
WHITE / YELLOW
CAN L OUTPUT
R-LADDER WIRES
PINK
V1 INPUT
YELLOW
V2 INPUT
PINK / BLACK
V1 OUTPUT
YELLOW / BLACK
V2 OUTPUT
GMLAN WIRES
GREY
GMLAN INPUT
GREY / YELLOW
GMLAN OUTPUT
WIRE COLOUR
Rev 2.15
13
MediaDAB HD
MEANINGS
CHANNELS
are the radio stations stored in the DAB receiver
.
.
CLEAR FAVOURITE
this option allows to delete all the channels memorized as favourite.
SCAN
is the operation managed by MediaDAB HD during the channels research.
PRUNE
is the operation that allows to clear channels listed but not yet available.
POWERSCAN (PWR SCAN)
if enabled this function manages a SCAN each time the device is activated.
RESTORE
allows to reset the DAB module of the device.
RDS MODE
changes the RDS version used: normal (8 characters) and estende (64 characters)
DLS
Dynamic texts.
RSSI
Signal intensity.
SNR
Signal to noise ratio.
MSC
Signal quality.