®
I n s t r u c t i o n S h e e t
0 1 2- 0 7 30 8 G
pH Sensor
PS-2102
Included Parts
1.
pH amplifier
2.
pH electrode
3.
Storage bottle containing storage solution
Additional Part Required
•
PASPORT interface or datalogger
Related Parts
•
Replacement electrode (PASCO part 699-195)
•
Flat-surface electrode (PS-2182)
•
pH buffer set (SC-2321)
Quick Start
1.
Connect the amplifier to your PASPORT interface.
2.
Connect the pH electrode to the amplifier.
3.
If you are using a computer, connect the PASPORT interface
to it and start DataStudio.
4.
Remove the storage bottle from the electrode.
5.
Rinse the electrode with distilled water.
6.
Immerse the end of the electrode in the solution to be mea-
sured.
7.
Press or click the start button to begin recording data.
Introduction
The pH Sensor measures the pH of a solution. The measurement
is recorded and displayed by the connected computer or datalog-
ger. The pH Sensor is well-suited for continuous recording and
discrete measurements.
Set-up
Connecting the Parts
1.
Plug the sensor’s PASPORT connector into any port of a
PASPORT interface or datalogger.
2.
Push the connector at the end of the electrode cable onto the
sensor’s electrode connector. Twist the connector to lock it in
place.
Connecting the electrode and interface
3.
If you are using a computer, connect the PASPORT interface
to it and start DataStudio.
to PASPORT
interface
pH electrode
