PASCO ME-9858, Инструкция по эксплуатации

Страница: 6 / 13

Model No. ME-9858 Physical Pendulum Accessory
5
®
2. a) Attach the pendulum bar by sliding the pivot pin into the middle of the pendulum
bearings. Insert the pivot rod into the exact hole shown on the peg board (Figure 2a).
b) Place a normal length support peg in the hole as shown at the top of the swing (Figure
2a). This acts as a stop to prevent the pendulum rotating more than 180
o
.
3. a) Put the bumper on the car, as shown in Figure 3a. Use two rubber bands. b) Release the
car "backwards" with the rubber band part of the bumper in front.
Note: The bumper pin on the end of the pendulum must hit the middle of the rubber band
(Figure 3b). Adjust the position of the track side to side to achieve the correct position. If the
bumper is not the correct height to hit the pin, you have the pivot support rod in the wrong
hole.
bumper
pivot rod
peg
Figure 2a: Front view of
pendulum with pivot pin
pivot rod
support peg
Figure 2b: Side view of
pendulum with pivot pin
Figure 3a: Bumper on Car
Figure 3b: Bumper against Pin on
Pendulum
bumper