Model No. ME-8594
012-08438A
3
!
4.
Use three-fingered clamps to attach the reservoir to a rod stand (Figure 2).
5.
Connect the top hose to a water faucet. (
Note:
Keep the rod stand below the height of the
water faucet to allow water flow to travel downward.) Turn on the tap water and allow
water to flow in through the top port.
6.
For a pre-measured volume: Fill the cylinder to about 800 mL, and turn off the water.
Open the clamp to the bottom tube, allow the water level to drop to the desired level, then
close the clamp.
OR
For a constant pressure or head: Adjust the flow from the tap so that the water doesn’t
flow in from the tap faster than the overflow (from middle fitting) going to the sink.
[
Note:
With water flowing in from the tap and out through the overflow, the water level
stays constant (as long as the water output is less than the tap water entering the cylinder.)]
For more information about using the Water Reservoir with the ET-Hydro Accessory, see the
instruction sheets supplied with the ET-Hydro Accessory and ET-Generator Manual.
