®
L a r g e S t r u c t u r e s S e t
C a r B u i ld i n g J u m p
10
Car Building Jump
Use beams, connectors, cord (for cross bracing), and a section of Coaster Track to build a ramp next to a building.
Use Track Clips to attached the Coaster Track to the ramp. Add a Mini Car Starter Bracket to the top of the ramp
and let a Mini Car roll down the ramp and “jump” onto the adjacent building’s landing platform.
Adjust the position of the building as needed so that the car lands on top of the building.
*Make a landing platform using a square of cardboard or foam core board.
If the building is too high or too low, change the beams at the bottom of the building. Replace the #2 beams with
#1 beams, or remove the bottom beams altogether.
Figure: Car Building Jump
Flex 4
Legend:
AC = Angle Connector
FR = Full Round Connector
FT = Flat Round Connector
HR = Half Round Connector
SL = Sliding Connector
ST = Straight Connector
AC
AC
#4
#4
#4
#4
#4
#4
ST
ST
#4
SL
#5
SL
SL
#5
#3
#3
#3
#3
#3
#3
SL
ST
#1
#3
#2
#2
#4
#6
#6
#4
#4
ST
#5
#5
#6
#6
#6
#6
#6
Use two #3 beams
and a Straight
Connector to make
twelve #5 beams.
FT
FT
HR
HR
FL
Flex 3
#4
#4
#4
#3
HR
FR
#6
#5
#5
#5
Flex 5
Flex 4
#4
#3
2 x
3 x
#2
#2
Landing
platform*
Flex 5
Flex 3
Flex 3