47
Turn off operation
Turn off the UPS in line mode
1.
Press and hold the OFF key for more than half a second to turn off the
UPS and inverter.
2.
After the UPS shutdown, the LEDs go out and there is no output. If output
is needed, you can set bps “ON” on the LCD setting menu.
Turn off the UPS by DC without mains power
1.
Press and hold the OFF key for more than half a second to turn off the
UPS.
2.
When turning off the UPS, it will do self-testing firstly. The LEDs light and
go out circularly and orderly until there is no display on the cover.
UPS self-test/mute test operation.
1.
When the UPS is in line mode, press and hold the self-test/mute key for
more than 1 second, the LEDs light and go out circularly and orderly. The
UPS comes to self-test mode and tests its status. It will exit automatically
after finishing testing, and the LED indication will go back to previous
status.
2.
When the UPS is in battery mode, press and hold the self-test/mute key
for more than 1 second, the buzzer stops beeping. If you press and hold
the self-test/mute key for one more second, it will restart to beep again.
Configuring Battery Settings
Set the UPS for the number of EBPs installed.
To ensure maximum battery runtime, configure the UPS for the correct
number of EBPs, refer to Table 8 for the appropriate setting of battery
numbers and type. Use the up and down scroll keys to select the number
of battery strings according to your UPS configuration:
