© PartyFunLights.com
Getting started
Please read these safety precautions carefully before using this product. Keep them for
future reference and for new users who are not familiar with the product.
Warnings
•
Supply voltage of this product is DC 5V 2A MAX - USB port
•
Never connect to DC 24V or AC 220V.
•
Never connect the front and back port in case of a short circuit.
•
Lead wire should connected correctly, according to colors on the wire.
Contents
•
This product must only be used as intended in accordance with these instructions.
•
Before first use, remove all packaging and inspect the device for damage.
•
CAUTION: Install batteries in the correct position as shown in this manual.
Installation by adult recommended.
•
Do not dispose of batteries in fire.
•
This product has not been designed for use by children.
•
Adult supervision is always required when children are near any electrical
appliance.
•
This product has been designed for indoor use only.
•
Keep the product and the cables away from water and other liquids. If the product
does fall in water, immediately disconnect the power supply. Do not attempt to
touch or pull the product out of the water when it is connected to a device that is
connected to the main power supply.
•
Never touch the product or the cables with wet hands.
•
Make sure the product is not connected to a power supply when not in use.
•
Do not replace the connector cables by yourself.
•
This product flashes that may trigger photosensitive epilepsy to sensitise
individuals. Take care when using.
•
The external flexible cable or cord of this luminaire cannot be replaced; if the cord is
damaged, the luminaire shall be destroyed.
•
The light source of this luminaire is not replaceable; when the light source reaches
its end of life the whole luminaire shall be replaced.
•
The product shall be supplied by a external independent LED driver with at least 5V,
2A SELV output.
How to use
1. Clean the surface you intend to stick the light strip to.
2. Peel off the backing strip of the adhesive tape.
3. Press and hold the light strip firmly against the surface.
