6m x 12m Peg & Pole Electron Marquee Setup Instructions (1 piece roof) – Party Warehouse. Page 3 of 3
4) Handy Tip:
Give the ground pegs one to two more hits, this increases the tension on the guy
ropes and improves the tension across the roof. If a peg has come lose during
the erection, this is the point to hammer into a fresh hole. If the guy rope is
sufficiently taut the peg will not require further hammering, excessive tension will
cause the guy rope to break.
5) Walls:
Attach the walls to the roof using the rope that runs around the perimeter of the
roof. Start attaching the walls in one corner with the pockets facing inside.
Working around in one direction hang the walls from the aforementioned rope
keeping the wall taut. This will ensure there is no bunching of the wall material.
The walls join together with a lace system, take the top lace and feed through the
top eyelet on the opposing wall. The next lace goes through the second eyelet,
then through the loop in the first lace and pull down. Repeat this sequence till the
bottom of the wall is reached then tie off the rope at the bottom.
To secure the walls to the ground, use the small wall pegs provided. These are
placed through the eyelets in the wall.
6) Dismantling:
To dismantle this marquee complete the erection steps in reverse order. Make
sure that when dismantling the marquee that you pay attention to the labels on
the bags and you put the components in their corresponding bags. When folding
the walls and roof section please try to avoid muddy areas.
