3
EN
IMPORTANT NOTE ON LITHIUM-ION BATTERIES
1. PRIOR to using the unit for the first time, please charge fully the battery
2. Charge the battery regularly after each use. Don’t wait until it is discharged!
3. DON’T allow the battery to discharge completely, otherwise it will lose 20% of its capacity or
even be totally damaged!
If the voltage becomes too low, the internal circuits are not powered anymore and it will become
impossible to recharge the battery!
4. If you don’t use the unit for a longer period of time, it is recommended to charge it at 40% of
its capacity and check/charge it once per month.
** BATTERIES ARE NOT COVERED BY THE WARRANTY **
We cannot be held responsible for damaged batteries further to the non-observance of these
basic rules.
Location of Controls
1
2
3
4
5 6 7 8
9 10 11
12
1. Mic Stand Holder
2. Handle
3.
Light effect switch
4. LED indicator
5. ON/OFF switch
6. Micro-USB Charging Port
7. 3.5mm Auxiliary Input Port
8. Mic 1 Input
9. Mic 2 Input
10. Mic Volume Knob
11. Mic Echo Knob
12. Master Volume Knob
Using the speaker
Flip the on/off switch to the ON position to switch the speaker on. A tone will be heard, and the speaker will
enter into Bluetooth pairing mode. The speaker will automatically re-connect to any nearby, previously-paired
device when the Bluetooth function is enabled. Flip the on/off switch to the OFF position to switch the speaker
off.
Playing Music
To play music, you must be connected to a Bluetooth-enabled device or connected via an AUX cable (See the
chapters "Bluetooth Pairing" and "Use with a Wired Device" of this user manual). Once connected, audio play-
back and volume adjustment can be controlled via your paired media-playing device.
Bluetooth Pairing
1.
Power the speaker ON. A tone will be heard and the LED indicator will quickly flash BLUE.
2. Enable the Bluetooth search function on your mobile device. Select “PARTY-SINGER” in the list of found de-
vices.
3.
After successful pairing, a tone will be heard and the LED indicator will slowly flash BLUE .
Use with Wired Device
Insert one connector of a 3.5 mm auxiliary cable into the 3.5mm auxiliary input port on the top of the speaker.
Insert the other connector into the headphone jack of your media-playing device. The LED indicator will light
BLUE when an AUX cable is connected.
All Bluetooth pairings will be disconnected while the 3.5mm AUX jack is connected.
Operation of the LED light effect
Press the [LED] button to cycle through the light modes.
