8
9
Keypads
S
P832-LCD(Z) Keypad
P832-16(Z) LED Keypad
The
Liquid Crystal Display
(LCD) displays prompts
and system information on two 16 character lines.
If “< >” appears, more information can be accessed by
using the arrow (< >) keys. Press
[<]
to see the
previous function or item of information. Press
[>]
to
advance the display to next function or item of
information.
Press the keys on the number pad as prompted by the
LCD display to view alarms or troubles, to arm and
disarm the system and to bypass zones.
To exit a function and return to the Ready state,
press [#].
To select a function press [
✱
].
Emergency Keys (All Keypads)
P832-08Z, P832-16Z, P832-32Z, P832-LCDZ:
Press both * Keys for two seconds to send a FIRE
transmission.
Press both
* Keys for two seconds to send an
AUXILIARY transmission.
Press both * Keys for two seconds to send a PANIC
transmission.
* IMPORTANT NOTE (All Keypads): The Fire,
Auxiliary and Panic keys will NOT function unless
programmed by the installer. If these keys are in
service and the installer has enabled audible
feedback, holding down the key for two seconds
will cause the keypad sounder to beep indicating
that the input has been accepted and transmission
is underway.
NOTE: In the U.S.A. the [A] and
keys are
programmed to be used for non-medical
emergencies only, as per UL requirements.
Important Note: Test system weekly and have any system trouble conditions corrected by
your alarm installer.
Display Lights (All Keypads)
Memory Light
Upon disarming, if an alarm has occurred while the
system was armed, the Memory light will turn ON
(See “Disarming the System” on page 6).
Bypass Light
If the Bypass light is ON, one or more zones are
bypassed (See “Zone Bypassing”
on page 11).
Fire Light
If the Fire light is ON, a fire alarm has occurred (See
“Fire Alarm Operation” on page 14).
Program Light
The Program light will flash when you are
programming access codes, or performing other
programming functions. If someone is programming
at another keypad, the Program light will turn ON to
indicate that the system is busy.
Ready Light
If the Ready light is ON, the system is ready for
arming. The system cannot be armed unless the
Ready light is ON (see “Arming the System” on page
4).
Armed Light
If the Armed light is ON, the system has been armed
successfully.
Trouble Light
If the Trouble light is ON, see “Viewing Trouble
Conditions” on page 11.
The
P832-16, P832-16Z, P832-32
and
P832-32Z
Keypads are available for applications with more than
8 zones. The functions explained in this manual are
the same for all three LED keypad types.
P832-08(Z) LED Keypad
P832-32(Z) LED Keypad
