Operating Instructions
1. Place the desired cable and terminal into the open head of the tool
and snap the head back into the closed position.
NOTE:
For best results, the cable and terminal must be
positioned at the
CENTER
of the upper die as this will
balance the compression load ratio and not cause distortion of
die or head.
2. Release the handle catch between the bottom of the handles, the
moving handle will then spring open.
3. Pump the moving handle, the ram will rapidly advance. When the
lower die makes contact with the terminal connector the tool will
then slowly press the terminal until full compression is reached.
4. Continue pumping until both dies are touching. Operation is
complete when the hydraulic pressure reaches 550bar, and the
relief valve releases the internal pressure.
5. Press the release trigger and close handles to retract the piston.
Open the tool head and remove the crimped terminal or reposition
if further compressions are required.
6. Clean the product and dies after use. Apply rust preventive oil to
the product and dies before putting them back in the carrying
case.
ISSUE: 10/13 ORIGINAL
PAGE 7
Содержание PHCT240-Kit
Страница 14: ...Parts Drawing ISSUE 10 13 ORIGINAL PAGE 13...
