ParTech TurbiTechw2 LR, Инструкция по эксплуатации

Страница: 20 / 34

TurbiTechw² LR Instruction Manual
8.2 M:0x – Measurement Channel
Selecting a measurement channel will reveal a new sub-menu associated
with that measurement. In
MEASUREMENT CONFIG press to
highlight the required measurement and press .
The sub-menu is as follows:
8.2.1 M:0x Info
This option provides additional information on the measurement, this
information will only be required if a problem exists with the instrument
performance.
8.2.2 M:0x Title
This allows the title of the measurement to be changed from it's default,
the measurement title is used in measurement mode to identify the
measured value. A selection of standard terms are available along with a 'User Defined' option that
can be adjusted to suit your requirements. For example this could be changed to 'Turbidity Line 1'. The
maximum number of characters is 20.
8.2.3 M:0x Units
This allows the units of the measurement to be changed from it's default, the measurement units are
used in measurement mode. A selection of standard terms are available along with a 'User Defined'
option that can be adjusted to suit your requirements. The maximum number of characters is 4.
8.2.4 M:0x Set Zero
The term relate to the calibration of the system and is covered in the section below.
8.2.5 M:0x Set Cal
The term relate to the calibration of the system and is covered in the section below.
8.2.6 M:0x Averaging
This allows the user to impose averaging on the measured value, this is used to reduce the speed of
reaction to the process changes. The value can be adjusted between 0 and 6000, the higher the value
the slower the reaction time.
8.2.7 M:0x Remove
This allows the user to remove a measurement that has been selected in
error or to allow re-configuration of the system. Please use this option with
care, all user settings will be lost if the measurement is removed in error.
8.2.8 M:0x Display Position
This option allows the position of the measurement to be moved. For
example the Colour measurement can be changed from M:01 to M:02 so it will appear second on the
list in MEASUREMENT CONFIG menu.
Page 20 of 34 225769IM - Issue - 05 Issue Date 30/04/2019
M:01 CONFIG
M:01 Info
M:01 Title
M:01 Set Zero
M:01 Averaging
M:01 Remove
M:01 Units
M:01 Set Cal
M:01 CONFIG
M:01 Info
M:01 Title
M:01 Set Zero
M:01 Averaging
M:01 Remove
M:01 Units
M:01 Set Cal
MEASUREMENT CONFIG
Measurement Status
Add Measurement
M:01 Turbidity (S:01)