Parsun F40 EFI, Руководство по обслуживанию

Страница: 104 / 119

99
Disassemble
1. Completely warp the outboard motor upward, and push it in the warping limit shaft to
support the outboard motor.
2.
Remove the circlip 9, and remove the warping hinge pin.
3.
Remove bolts and hydraulic positioning shaft.
4.
Remove the manual cylinder assembly
Check the oil level.
1. Position the hydraulic warping device vertically and fix it.
2. Connect the lead of the warping motor of the hydraulic warping device to the battery.
3. Extend the push rod completely, remove the oil screw, and observe the oil level.
Note:
The oil level should be at the edge of the oil hole,
1. Oil drain screw
4. If necessary, add oil to the edge of the oil hole.
5. Install the oil drain screw and tighten it.
Specified torque: 6.5 Nm
Exhaust the air in the oil line of the hydraulic warping device.
After adding oil, discharge the excess air in the oil.
1. Connect the lead of the warping motor of the hydraulic warping device to the battery.
2. Extend the push rod completely.
3. Exchange the positive and negative wire connections.
4. Completely compress the push rod.
5. Repeat steps 1~4 to make the push rod move up and down 4~5 times.
6. Extend the push rod completely, remove the oil screw, and observe the oil level.
7. If necessary, repeat the above steps until the oil level is correct.
8. Install the oil drain screw and tighten it.
Specified torque: 6.5 Nm