Parsun F15AEFI BM, Руководство пользователя

Страница: 44 / 79

37
2. Unscrew the filter cup, catching any spilled fuel in a rag.
3
. Remove the filter element, and wash it in solvent. Allow it to dry. Inspect the filter element and O-ring
of the filter cup to make sure they are in good conditions. Change them if necessary. If any water is
found in the fuel, check and clean the portable fuel tanks should be checked and cleaned.
1. Filter cup 2.O-ring 3. Filter element 4.Filter housing
4. Reinstall the filter element in the cup. Make sure the O-ring is in position in the cup. Firmly screw the
cup onto the filter housing.
5. Attach the filter assembly to the bracket so that the fuel hoses are attached to the filter assembly.
Run the engine and check the filter and lines for leaks.
3.4 Inspecting idling speed
Use a diagnostic tachometer. Results may vary depending on whether the outboard motor is tested in
a test water tank with a flusher device, or in the water.
1. Start the engine and allow it to warm up fully in neutral until it is running smoothly.
2. Verify whether the idle speed is set to specification. Idle speed
：
1050±50Rpm
1
2
3
4