INSTRUCTION REF: IN104
ISSUE No. 2
DATE 10.04.06
Page 9 of 15
TELEPHONE:
SERVICE (44) 01332 875665
FAX:
SERVICE (44) 01332 875536
SERVICING/REPLACING PARTS P6BO/2
BEFORE ANY MAINTENANCE ISOLATE FROM SUPPLY
1.
HOB TAP
- Remove pan supports and fascia panel (2 screws on front).
Disconnect burner supply tube and thermocouple. Undo the 2 screws securing the tap
to the rail. Check sealing washer and replace if necessary. Assemble in reverse
order.
2.
HOB BURNER/THERMOCOUPLE
– Remove Pan Supports and Burner caps.
Unscrew hexagonal headed mixing tube from centre of burner assembly on front and
rear burners. Burner body and spillage shield can now be lifted off. Disconnect
thermocouple from rear of tap. Undo locknut on burner mounting channel. Assemble
in reverse order.
3.
OVEN THERMOSTAT
Proceed as for hob tap and remove right hand side panel.
Slide thermostat phial from housing inside oven. Remove through hotplate well.
Assemble in reverse order.
4.
OVEN THERMOCOUPLE
Remove screws in oven front base panel and lift panel
off. Access can now be gained to rear of thermocouple valve, undo thermocouple
from valve, undo locknut from oven burner, fit new thermocouple in reverse order.
5.
OVEN BURNER/IGNITON
Remove oven base. Disconnect oven supply tube, H.T.
lead and thermocouple. Burner is held in by 2 screws. Piezo spark generator is
secured by a locknut. Electrode secured to burner bracket by centre screw.
