Parrot Uncle F8219110V, Инструкция по использованию и уходу

Страница: 14 / 16

Installation & Operating Instructions for the
Parrotuncle Owner
'
s Installation ,Manual
WA RNING
: S
HUT POWER OFF AT FUSE OR CIRCUIT B REA K ER
3. THE FAN WOBBLES
Verify all blades and blade bracket screws are secure (most fan wobble problems are caused by loose parts). Once fan is properly
installed, run the ceiling fan for 10 minutes to let the fan self-adjust.
If wobble occurs a ti er running the fan for 10 minutes, verify blade level using the following process:
a) select a point on the ceiling above the
ti
p of one of the blades. Then select the fan blade and measure from the center
of the selected blade to point on the ceiling. Rotate the fan un
ti
l the next blade is posi
ti
oned and repeat the
measurement using the same point from the ceiling for every blade. Measurements should be within 1/8 inch.
b) If all devia ti on are less than 1/8 inch and the fan contnues to wobble, please contact Customer Service Support
@
parr
otuncle.com to order a complimentary Blade Balancing Kit
-If all devia ti onsare less than 1/8 inch and the fan con ti nues to wobble, pleasecontact Customer Service Support
@
parrotuncle
.com to order a complimentaryBlade Balancing Kit
4. LIGHT IS NOT WORKING
Check Bulb to make sure it is installed correctly
Remove non-working bulb and replace with a bulb that is known to be a good working bulb
To reset the remote control: 1) Turn o ff power to fan using the wall switch or circuit breaker. 2) Remove ba tt eries from
remote. 3) Wait 10 seconds. 4) Replace ba tt eries and turn power on
F8219110V